- Use one of the front inputs: as long as the incoming signal is not too hot, this should be the solution.
- Monitor in mono while recording - In the master section of the TC NEAR control panel, press the mono option. You can also push the button located above the output pot until the "mono" LED lights up.
Question When I connect a mono signal to one of the line inputs of the Impact Twin (i.e. from a mono preamplifier), I cannot get it to be in the center in direct monitoring. Is there a solution to that Answer Impact Twin line inputs 1/2 and 3/4 are paired for stereo. So you will not be able to monitor a mono signal in the center (as is possible on the Konnekt 24D) while recording. But the recording itself will be correctly done in a mono channel of the DAW, as each line input has its own Firewire line to the DAW (FW 1 to 4). As a workaround, you can try the following:
Keywords: Impact Twin: Line inputs cannot be used as mono channels for direct monitoring