In this example, it is assumed that an ADT1616 ADAT interface is connected to MODULE 1 on the DDX3216.   The signal will be sent through analog input channel 1, then routed through a Direct output to Module 1.


1.  Press the CH 1-16 button, the SELECT button on channel 1.2.  Press the ROUTING button. Make sure that none of the Buses are highlighted on that page (but MAIN should be highlighted for use in most mixes).

3.  Press the I/O button, and go to the INPUT page to highlight AN 1-8 (for analog inputs 1-8).4.  Go to the I/O menu OUTPUT page and highlight DI 1-2 as the SOURCE (for Direct out 1-2).5.  Press ENTER to accept the settings youve created at this point.6.  Go to the I/O menu MODULE page and highlight OUT 1-8 in the CH 1-8 list for MODULE 1 (on the left side of the display). Insert article content here!