Views:
new logo JPEG.jpg     Graphic Equalizer:   - Press the GEQ button to display the GEQ menu. - Turn the small Upper Data Wheel to select the frequency to deal with. - Turn the small Lower Data Wheel to select the bandwidth you want to affect. - Turn the Large Data Wheel to adjust the GAIN of the frequency. - For each control you will see visual feedback from the curve in the middle of the display and the numbers on the right of the display.    Parametric Equalizer:   - Press the PEQ button to display PAGE 1 of the PEQ menu. - Turn the small Upper Data Wheel to select the frequency to work with. - Turn the small Lower Data Wheel to adjust the bandwidth you want to affect.  - Turn the Large Data Wheel to adjust the GAIN of the frequency. - For each control you will see visual feedback from the curve in the middle of the display and the numbers on the right of the display.    Auto-EQ:   - Press the RTA button to show PAGE 1 of the RTA menu display. - Press the B button (next to the 'AUTO EQ' indicator on the left-hand side of the display). - Turning the Data Wheels will now adjust the target EQ curve that you want to achieve. - Press the PAGE button to advance to page 2 of the Auto EQ menu. - Press the A button (next to the 'START AUTOEQ' indicator on the left-hand side of the display) to start the Auto-EQ process. - Press the A button again to stop the process - Preass the PAGE button to advance to page 3 of the AEQ menu. - Press the B button (next to the 'DONE' indicator on the left-hand side of the display) to exit Auto-EQ mode.    Compressor/ Expander:   - Press the DYN button until PAGE 1 of the DYN menu is displayed. - Press the B button to switch between expander and compressor functions. - Use the Data Wheels to the right of the display to adjust the parameters.    Limiter Function:   - Press the DYN button until PAGE 2 of the DYN menu is displayed. - Press the B button (next to the 'LIMITER' indicator in the left-hand side of the display). - Use the Data Wheels to the right of the display to adjust the parameters.   Metering Displays   - Press the METER button. - Press the METER button or the PAGE button to cycle through the three different meters (peak/RMS, SPL, VU).   Stereo Delay   - Press the I/O button until PAGE 4 of the I/O menu is displayed. - Use the Data Wheels to the right of the display to adjust the parameters.   Stereo Imager   - Press the WIDTH button until PAGE 1 of the WIDTH menu is displayed. - Use the Data Wheels to the right of the display to adjust the parameters.    Module Bypass Function   - Press the BYP button to enter the Bypass screen. - Use the Large Data Wheel to select a module to bypass. - Press the B button to bypass the module. - Pressing the B button again will re-enable the module.