Views:

To add an accent into your pre-recorded sequence, firstly you need to be in PATTERN > WRITE mode. Then, complete the following steps:

  • Press PITCH (The LED will light up)
  • Press WRITE/NEXT to cycle through the notes in your pattern
  • When you get to a note that you want to add an accent to, keep WRITE/NEXT held down and press the ACCENT button.
  • If you go past a note you want to affect, press BACK and the WRITE/NEXT again

The ACCENT dial will then affect those notes with an accent on. Any note with an accent on cannot be affected by the DECAY dial.