Views:

SETTING SYNC and CLOCK TYPE

Selector switches 1, 2, 3, or 4 represent clock source INT, MIDI, USB, or TRIG respectively
Selector switches 5, 6, 7, or 8 represent clock rate 1PPs, 2PPQ, 24PPQ, or 48PPQ respectively

1. Press Function.
2. Make sure no sequence is playing.
3. Press BACK and WRITE/NEXT at the same time to enter Sync setting mode.
4. Selector 1 to 8LEDs will turn on, and the current clock source (1 to 4) and clock rate (5 to 8) will fl ash, you have about 3 seconds to make any changes.
5. Press Selector 1, 2, 3, or 4 to change the clock source to INT, MIDI, USB, or TRIG respectively
6. Press Selector 5, 6, 7, or 8 to change the clock rate to 1PPs, 2PPQ, 24PPQ, or 48PPQ respectively.
7. Press any other buttons or after no changes for a 3 seconds, the changes are saved. 8. Repeat step 3 to check your selection.

Caution: Clock source must always be INT (internal) if you are not using an external clock. Note: Clock rate 24 or 48 PPQ (Pulses per quarter) are recommended.