To stop upgrades of PRO3 to PRO6, or PRO6 to PRO9, etc, the surfaces are licensed. If an MC or scan processor is replaced or has to be re-programmed, then the surface will need to be re-licensed. This requires running the licensing software (LCAT). You will need to submit a case with the Midas Support Team for the relevant software and instructions. When you run the licensing tool, you will need to supply the Midas representative with a code and they will reply with the license code, so doing this at a amicable time would be helpful. The surface cannot be switched off as the code will change again on repower.
Keywords: PRO3, PRO3B, PRO6, PRO6B, PRO9, PRO9B, licence, license