Views:
                  When presets are stored as a unit, we will call them memories (scenes). In this example, well create and store two presets in BANK 1 of the memory. Start with the DMX dimmer packs set to receive on channels 1 to 3, with lights connected, and with all the LC2412 faders down.   The demonstration: 1. Power up the dimmer pack and the LC2412. 2. Press the QUIT button. 3. Use the LC2412 UP and DOWN button to make P appear in the BANK display.  It will flash for a few seconds, then remain lit. 4. Push up the MAIN and A faders, and then use faders 1, 2, and 3 in the A PRESET fader section to create a stage design with the lights. 5. Use the UP and/or DOWN button to select BANK 1 in the BANK display, then press the MEMORY button, and the following will appear in the PROGRAM display: SEL. MEMORY _ _ / 01 (top line) and PRESET   ALL (in the second line). 6. Press the FLASH 1 button (in the lower left of the LC2412 front panel), and the display will change to: SEL. MEMORY 01/01 (top line) and PRESET    ALL (bottom line). 7. Press the SOFT A button to choose saving a preset. 8. Press QUIT to leave the MEMORY function. 9. Use the UP and/or DOWN button to make P appear in the BANK display. 10. Use the 1, 2, and 3 faders in the A PRESET  section to create another stage design with the lights. 11. Use the UP and/or DOWN buttons to select BANK 1 in the BANK display, then press the MEMORY button, and the following wil appear in the PROGRAM display: SEL. MEMORY _ _ / 01 (top line) and PRESET   ALL (on the bottom line). 12. Press the FLASH 2 button, and the PROGRAM display will change to show:  SEL. MEMORY  02/01  (top line) and PRESET   ALL (on the bottom line). 13. Press the SOFT A button to choose saving a preset. 14. Press the QUIT button. 15. To recall the memory that was just created, start by pulling down fader A ad pushing up fader B. 16. You can now use the faders that are marked M1 or M2 in the B MEMORY fader section to recall the two presets that were just saved into memory slot numbers 1 and 2 in BANK 01.   Erasing memory settings: Press and hold the SOFT A and SOFT B buttons, press the FLASH 1 button (in the lower left of the display), and then turn the DATA wheel until DELETE ALL appears in the PROGRAM display.  Press the SOFT B button for YES.  REALLY ALL will appear in the display, and you will then press the SOFT B button for YES, and all memories will be cleared from the LC2412.